On this page
Splitting and Combining Workspaces in Sesam Wind Manager
In Sesam Wind Manager, you can run two or more workspaces at different PCs and combine them to get the report from all DLCs. However, as Sesam Wind Manager recognizes each analysis by their UniqueID, you must make sure they are consistent between workspaces.
If you have not created the workspace yet, you can follow these steps:
- Create and setup a new workspace with all the DLCs in one of the PCs
- Save and copy the workspace into other PCs. As an example, we will run it in two workspaces, A and B. Each workspace can be in different PCs.
- In each workspace, run different parts of the job. For example, first 3 DLCs in Workspace A, and remaining DLCs in Workspace B.
- Observe that in both the workspace folder (File > Explore Current Workspace) you have the analysis folders (one for each DLC).
- Close workspace A
- Copy the analysis folders in workspace B to workspace A. In this case, we want to combine workspace B into A (A as main).
- Reopen workspace A. You will see other DLCs are now marked as completed.
- After this, generate FLS or ULS result reports as you would do it normally to get maximum utilization between all combined DLCs.
If you already finished the job without preparing the workspace as shown above (i.e., you already have different workspaces with different DLCs), you need to follow these steps to make Sesam Wind Manager recognize the UniqueIDs of the DLCs:
- As an example, we have workspace A and workspace B as shown below. Both jobs are already completed separately.
- Observe that in the workspace folder (File > Explore Current Workspace), in addition to the analysis folders, you also have an XML file. We will use this XML file to copy the UniqueIDs.
- Copy the analysis folders in workspace B to workspace A. In this case, we want to combine workspace B into A (A as main).
- Open the XML files of workspace A and B in any text editor. It is better to close the workspaces first to avoid conflicts.
- Copy the elements (data) between
and tags from Workspace B's XML to Workspace A's XML. This is the data of the Wave/Wind table's DLC in Sesam Wind Manager.
- Save Workspace A's XML.
- Open Workspace A in Sesam Wind Manager. If done correctly, you would see the finished DLCs from workspace B are copied to workspace A, including the results.
- After this, it is the same as before.
Note: You do not need to copy any R#.SIN file as they are not used for the report and can be quite large